Table of Contents
Advertisement
This machine is designed to operate in closed rooms and must be placed stable on a firm
and level surface. For safe operation of the scroll saw, the machine should be secured to
a solid work surface, bench or stand.
• A workbench made from solid wood is better than one made of plywood, as interfering
vibrations and noise are more noticeable with plywood.
THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH
WARNING
!
MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.
TO REDUCE RISK OF INJURY:
• When carrying the saw, hold it close to your body to avoid injury to your back. Bend
your knees when lifting the saw.
• Carry the saw by the base, table or housing. DO NOT carry the saw by the upper arm,
motor or power cord.
• Secure the saw in a position where people cannot stand, sit, or walk behind it. Debris
thrown from the saw could injure people standing, sitting, or walking behind it.
Securethe saw on a firm, level surface where the saw cannot rock. Make sure there
is adequate room for handling and properly supporting the workpiece.
DUST COVER INSTALLATION
1.
Secure the dust hood to the machine by
threading the Phillips screws (Fig. 1, 1) through
the holes in the hinge.
2. Tighten the locking knob (2).
Note: This machine is equipped with a 90°
elbow for easy dust hose fitting. See page 9.
ALIGN THE BEVEL INDICATOR
The bevel indicator has been adjusted at the factory, but should be rechecked prior to
use for best operation.
1. Loosen the blade guard knob (Fig. 2, 1) and move the blade guard (2) all the way up.
2. Check if the pointer is on the 0 scale. If not, first Loosen the table level lock handle
(Fig. 3, 3) and turn the table level knob (4) to bevel the table until it is approximately at a
right angle to the blade.
ASSEMBLY & ADJUSTMENTS
1
10
2
FIGURE 1
Advertisement
Table of Contents
