Specifications
•
Resetting the product to factory default settings. See Reset to factory default settings on page 29.
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet Plus (PoE+).
UL: Power over Ethernet (PoE) shall be supplied by a UL 294 listed Power over Ethernet IEEE 802.3af/802.3at Type 1 Class 3 or Power
over Ethernet Plus (PoE+) IEEE 802.3at Type 2 Class 4 power limited injector that provides 44–57 V DC, 15.4 W / 30 W. Power over
Ethernet (PoE) has been evaluated by UL with AXIS T8133 Midspan 30 W 1-port.
Reader connector
One 8-pin terminal block supporting both OSDP and Wiegand protocols for communication with the reader.
It can connect up to two OSDP readers (multi-drop) or one Wiegand reader. 500 mA at 12 V DC is reserved for all readers connected
to the door controller.
Configured for one OSDP reader
Function
DC ground (GND)
DC output (+12 V)
A
B
Configured for two OSDP readers (multi-drop)
Function
DC ground (GND)
DC output (+12 V)
A
B
Important
• When the reader is powered by the controller, the qualified cable length is up to 200 m (656 ft). Verified only for Axis readers.
• When the reader is not powered by the controller, the qualified cable length for reader data is up to 1000 m (3280,8 ft) if the
following cable requirements are met: 1 twisted pair with shield, AWG 24, 120 ohm impedance. Verified only for Axis readers.
Configured for one Wiegand reader
Function
DC ground (GND)
Pin
1
2
3
4
Pin
1
2
3
4
Pin
1
Note
Supplies power to reader.
Half duplex
Half duplex
Note
Supplies power to both
readers.
Half duplex
Half duplex
Note
24
Specifications
0 V DC
12 V DC, max 500 mA
Specifications
0 V DC
12 V DC, max
500 mA combined for both
readers
Specifications
0 V DC