Led Indicators; Buttons; Connectors - Axis use-IP A1610 User Manual

AXIS A1610 Network Door Controller
Specifications

LED indicators

LED Color
Network Green
Amber
Unlit
Status Green
Amber
Red
Power Green
Amber
Relay Red
overcurrent
Unlit
Reader Red
overcurrent
Unlit
Relay Green
Unlit
1. Relay is active when COM is connected to NO.
Note
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > Additional Controller Configuration >
System Options > Maintenance .

Buttons

Control button
The control button is used for:
• Resetting the product to factory default settings. See Reset to factory default settings on page 27.

Connectors

Network connector
RJ45 Ethernet connector with Power over Ethernet Plus (PoE+).
UL: Power over Ethernet (PoE) shall be supplied by a UL 294 listed Power over Ethernet IEEE 802.3af/802.3at Type 1 Class 3 or Power
over Ethernet Plus (PoE+) IEEE 802.3at Type 2 Class 4 power limited injector that provides 44–57 V DC, 15.4 W / 30 W. Power over
Ethernet (PoE) has been evaluated by UL with AXIS T8133 Midspan 30 W 1-port.
Reader connector
Two 8–pin terminal blocks supporting both RS485 and Wiegand protocols for communication with the reader.
The specified power output values are shared between the two reader ports. It means that 486 mA at 12 V DC is reserved for all
readers connected to the door controller.
Indication
Steady for connection to a 100 MBit/s network. Flashes for network activity.
Steady for connection to a 10 MBit/s network. Flashes for network activity.
No network connection.
Steady green for normal operation.
Steady during startup and when restoring settings.
Slow flash for failed upgrade.
Normal operation.
Flashes green/amber during firmware upgrade.
Steady when short circuited or if overcurrent has been detected.
Normal operation.
Steady when short circuited or if overcurrent has been detected.
Normal operation.
1
Relay active.
Relay inactive.
21