Planet VC-23 Series User Manual page 16

Main office/PBX,
Telco CO,
wire closet
LAN1
Refer to the following procedures to set up the VDSL2 Bridge
LAN to LAN connection.
1. [LAN1] Set the VDSL2 Bridge at LAN 1 to be CO mode from
the DIP switch.
2. [LAN2] Set the VDSL2 Bridge at LAN 2 to be CPE mode
from the DIP switch.
3. Power on the VDSL2 Bridge CO and CPE at both sides by
connecting its power source.
4. Power LED will illuminate.
5. Connect VDSL line from another VDSL device to RJ11 VDSL
port of the VDSL2 Bridge.
6. VDSL LNK LED will blink to illuminate at both VDSL2
bridges.
7. Connect telephone to the RJ11 Phone port of the VDSL2
Bridge.
8. Connect the VDSL2 Bridge Ethernet LAN port to other
network device via regular Cat.5 UTP cable for VC-231/
VC-234.
16
Ethernet over VDSL2 and Telephone Network
Telephone wire
Up to 1.4km
Splitter
VC-231/CO
VDSL2
Splitter
VC-231/CPE
LAN2