Point-To-Multipoint Application; Connect To Ip Dslam - Planet VC-23 Series User Manual

4.2 Point-to-Multipoint Application -- Connect to IP
DSLAM
To build a local Internet in apartment, hotel and campus and
hospitality environments, it requires:
¾ The multi-port VDSL2 IP DSLAM or VDSL2 switch (for
example, PLANET VC-820M) operates as a CO Master and
needs to be placed in the wiring center (MDF room) and
connects to the telephone line system.
¾ On the other hand, it needs to install a CPE Slave (VC-231/
VC-234 VDSL2 Bridge) on the individual client side and
connect to the Multi-port Master through the telephone lines.
Ethernet over VDSL2 and Telephone Network
Main office/PBX,
Telco CO,
wire closet
Internet
Refer to the following procedure to set up the VDSL2 Bridge to
IP DSLAM connection.
1. [Remote End] Set the remote IP DSLAM/VDSL2 switch to
CO mode with proper VDSL2 profile.
2. [Local End] Set the VDSL2 Bridge at the local end to CPE
mode from the DIP switch.
VDSL2
VDSL2 Switch
Telephone wire
(Multi-port CO)
VC-231/CPE
VDSL2
UP to 1.4km
VC-231/CPE
Router
Splitter
LAN1
Splitter
LAN2
17