Table of Contents
Advertisement
3. Power on the VDSL2 Bridge CPEs by connecting its power
source.
4. Power LED will illuminate.
5. Connect VDSL line from IP DSLAM/VDSL2 switch to RJ11
VDSL port of the VDSL2 Bridge.
6. VDSL LNK LED will blink to illuminate.
7. Connect telephone to the RJ11 Phone port of the VDSL2
Bridge.
8. Connect the VDSL2 Bridge Ethernet LAN port to other
network device via regular Cat.5 UTP cable.
When deciding where to put the converter and/or prolong the
operational life of the bridge, please also refer to the following
points:
¾ It is accessible and cables can be connected easily.
¾ Cabling is away from sources of electrical noise such as
radios, transmitters, motors, power lines and fluorescent
lighting fixtures.
¾ Do not place objects on top of any unit or stack.
¾ Water or moisture cannot enter the VDSL2 Bridge.
¾ Air flow around the unit and through the vents in the side of
the case is not restricted (we recommend that you provide a
minimum of 25mm clearance).
18
Advertisement
Table of Contents
