Advertisement
Quick Links
Package Contents
AP-303H-MNT2 plastic mount bracket
Front cover slider
(x4) #6-32x1 slotted screws
(x2) M2.5x6.5 T8H Hex screw
AP-303H-MNT2 Mount Kit Installation Guide
Introduction
The AP-303H-MNT2 Mount Kit may be used to secure a 303H Series access point to a dual-gang wall
box according to the installation procedure provided below.
Installing the Access Point
Use the following instructions to install the AP-303H-MNT2 mount kit.
1. If the wall box is not already exposed, unscrew and remove the existing wall plate, as shown in
Figure
Figure 1 Removing Existing Wall Plate
2. If needed, detach any RJ45 cables by unclipping the connectors from the wall plate, or cutting/
removing the UTP cable(s).
March 2017
0511970-03 |
AP-303H-MNT2 Mount Kit
1.
Installation Guide
1
Advertisement
Related Manuals for HPE AP-303H-MNT2
Summary of Contents for HPE AP-303H-MNT2
- Page 1 AP-303H-MNT2 Mount Kit Installation Guide Introduction The AP-303H-MNT2 Mount Kit may be used to secure a 303H Series access point to a dual-gang wall box according to the installation procedure provided below. Installing the Access Point Use the following instructions to install the AP-303H-MNT2 mount kit.
- Page 2 Pass Through (PT) ports if needed. Installation for Single Gang Wall Box To install the AP-303H-MNT2 mount kit to a single gang wall box, refer to steps 4-5. 5. Align the screw holes on the mounting bracket with the corresponding holes on the single gang...
- Page 3 Figure Figure 4 Securing AP-303H access point to wall mount 11.Push the access point against the holes and then downward until the posts engage the slots at the top of the mounting holes. AP-303H-MNT2 Mount Kit | Installation Guide...
- Page 4 14.Insert the security screw into the hole located on side of the cover and turn until snug. 15.(Optional) If the access point requires a DC power adapter, a power cable may be inserted into the socket located on the side of the access point. 0511970-03 AP-303H-MNT2 Mount Kit | Installation Guide...