Advertisement
12.Once the access point is attached to the wall mount, insert the T8H Torx security screw into the
hole located on the right side of the mount and turn until snug.
13.Position the posts on the back of the front cover inside the slots on the mount housing, then slide
the cover into the locked position, as shown in
Figure 5 Fitting the front cover slider onto wall mount
14.Insert the security screw into the hole located on side of the cover and turn until snug.
15.(Optional) If the access point requires a DC power adapter, a power cable may be inserted into the
socket located on the side of the access point.
0511970-03
Figure
5.
AP-303H-MNT2 Mount Kit | Installation Guide
Advertisement
