Package Contents
Mount bracket
RJ45 coupler
RJ45 cable
M3 x 10mm pan head screws (4)
T6 Torx security screw
AP-310-MNT-W3 Mounting Template
Introduction
The AP-310-MNT-W3 mount kit offers a secure mounting solution for 310 Series Campus Access Points.
This mount kit attaches to standard single and dual gang wall boxes, or mounts to a flat surface, such as a
wall or ceiling.
The DC power plug and Kensington lock cannot be used with this mount.
This mount is not compatible with large (4.5in x 4.5in) US wiring boxes.
Installing the AP-310-MNT-W3 Mount Kit
!
Failure to properly install the AP-310-MNT-W3 may result in damage to equipment and/or bodily injury.
To install the mount bracket onto a flat surface, see
install the mount bracket onto a wall box, see
mount bracket onto a European wall box, see
Installing the AP-310-MNT-W3 to a Flat Surface
!
Before installing the AP-310-MNT-W3 to any surface, ensure that the surface can support the combined weight of
the mount kit and access point.
1. (Optional) Remove the punch-out panel on the side of the mounting bracket by pressing firmly.
2. Tape the AP-310-MNT-W3 Mounting Template flat onto the desired location, then drill holes at the
points indicated.
0511855-01 |
May 2018
AP-310-MNT-W3 Mount Kit
Installing the AP-310-MNT-W3 to a Flat
Installing the Mount Bracket onto a Wall
Installing the Mount Bracket to a DIN or European Wall
Installation Guide
Surface. To
Box. To install the
Box.
1