HPE AP-303H-MNTD Installation Manual

AP-303H-MNTD.fm Page 1 Monday, February 27, 2017 2:49 PM
Package Contents
Mount stand

Mount cover

M2.5x7, T8 Hex screws

(x2) M2.5x12, T8 Hex screw

RJ45 Ethernet jumper

AP-303H-MNTD Desk Mount Kit Installation Guide

Introduction
The AP-303H-MNTD Desk Mount Kit is a stand-alone mount for the 303H access point. This kit is equipped with
an Ethernet cable which may be used to link the E0 and PT ports on the back of the access point to enable uplink
capability from the E0 port located on the bottom of this device.
Mount Kit Assembly
1. Insert the mount cover into the mount stand, then insert the M2.5x7, T8 Hex screw into the hole located on
the bottom of the stand and screw both pieces together
Attaching mount cover to stand
Figure 1
2. Link the E0 and PT ports on the back of the access point using the RJ45 Ethernet cable.
0511971-02 | February 2017
AP-303H-MNTD Desk Mount Kit
Installation Guide
(Figure 1).
1