HPE AP-220-MNT-W3 Installation Manual

Package Contents
Mounting bracket

RJ45 couplers (2)

Ethernet cables (2)

#6-32 x 1.5" slotted screws (4)

T6 M2 x 6mm pan head screw

AP-220-MNT-W3 Drill Template

Introduction
The AP-220-MNT-W3 Mount Kit offers a secure mounting solution for 220 Series access points. This mount kit
attaches to standard single and dual gang wall boxes, or mounts to a flat surface, such as a wall or ceiling.
Installing the AP-220-MNT-W3 Mount Kit
Refer to the steps below for installing your AP-220-MNT-W3 Mount Kit.
To install the AP-220-MNT-W3 onto a flat surface, see
the mounting bracket onto a wall box, see
Installing the AP-220-MNT-W3 to a Flat Surface
1. (Optional) Remove one or both punch-put panel(s) on the sides of the mounting bracket by pressing firmly,
as shown in
Figure 1
2. Tape the AP-220-MNT-W3 Drill Template to the desired location and drill holes where indicated by the
template.
0511857-02 | June 2018
AP-220-MNT-W3 Mount Kit
Figure 1.
Removing the punch-out panels from the mounting bracket
Installing the AP-220-MNT-W3 to a Flat
Installing the Mount Housing onto a Wall
Installation Guide
Surface. To install
Box.
1