Advertisement
3. Use an Ethernet cable, to link the E0 port to an active RJ45 connector, or crimp an RJ45 plug to the
cable, and insert it into the E0 port.
4. (Optional) Use an AP-CBL-ETH10 Ethernet patch cable (purchased separately) to link the E0 port
and Pass Through (PT) ports if needed.
Installation for Single Gang Wall Box
To install the AP-303H-MNT2 mount kit to a single gang wall box, refer to steps 4-5.
5. Align the screw holes on the mounting bracket with the corresponding holes on the single gang
wall box, as indicated in
Figure 2 Attaching the wall mount to a single gang wall box
6. Remove the #6-32x1 slotted screws from their bag and screw the wall mount onto the wall box.
Installation for Dual Gang Wall
If mounting the AP-303H-MNT2 mount to a dual gang wall box, refer to steps 6-7.
7. Align the screw holes on the mounting bracket with the corresponding holes on the dual gang wall
box, as indicated in
2
Figure
2.
Figure
3.
AP-303H-MNT2 Mount Kit | Installation Guide
Advertisement
