Clearing The Cmos - AOpen MX6E PLUS Manual

2.2.2 Setting the CPU Voltage
This motherboard supports Pentium II VID function, the CPU core voltage is
automatically detected, the range is from 1.3V to 3.5V.

2.2.3 Clearing the CMOS

JP14 Clear CMOS
1-2 Normal operation
(default)
2-3 Clear CMOS
The procedure to clear CMOS:
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pins 1-2.
5. Connect ATX power cable back to connector PWR2.
6. Turn on the system power.
7. Press during bootup to enter the BIOS Setup Utility and specify a
new password, if needed.
Tip: If your system hangs or fails to boot because of
over-clocking, please clear CMOS and the system will go
back to default setting (233MHz).
Tip: Except using JP14, you may also press <Home>
key. By this smart design, it would be more convenient to
clear CPU frequency setting. For using this function, you
just need to press <Home> key first and then press
Power button at the same time. Please note that do not
release <Home> key until POST screen appearing .
Hardware Installation
You need to clear the CMOS if you forget your
system password. To clear the CMOS, follow
the procedures listed below:
JP14
1 2 3
Normal Operation Clear CMOS
(default)
JP14
1 2 3
2-5