Table of Contents
Advertisement
Hardware Installation
2.3.3 Fan
Plug in the fan cable to the 3-pin fan connector onboard. The fan connector is
marked CPUFAN and FAN on the system board.
Note: Attach fan cable to either CPU FAN connector or
FAN connector. Both of these two fans connectors can
support hardware monitoring function, however, you can
only use the CPU FAN connector to control the fan
power ON/OFF.
2.3.4 PS/2 Mouse
The onboard PS/2 mouse connector is a 6-pin Mini-Din connector marked PS2.
The view angle of drawing shown here is from back panel of the housing.
2-8
GND
+12V
SENSE
CPUFAN & FAN
PS/2 Mouse
PCB
Advertisement
Table of Contents
