Table of Contents
Advertisement
Integrated Peripherals à Onboard Serial Port 1
Integrated Peripherals à Onboard Serial Port 2
Onboard Serial Port
1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Note: If you are using an network card, make
sure that the interrupt does not conflict.
Integrated Peripherals à Onboard UART 2 Mode
Onboard UART 2
Mode
Standard
HPSIR
ASKIR
•
-
Standard
Sets serial port 2 to operate in normal mode. This is the
default setting.
•
-
HPSIR
Select this setting if you installed an Infrared module in your
system via IrDA connector (refer to section 2.3 "Connectors").
setting allows infrared serial communication at a maximum baud rate of
115K baud.
•
-
ASKIR
Select this setting if you installed an Infrared module via IrDA
connector (refer to section 2.3 "Connectors"). This setting allows infrared
serial communication at a maximum baud rate of 19.2K baud.
This item allow you to assign address and interrupt for
the board serial port. Default is Auto.
This item is configurable only if the "Onboard UART
2" is enabled. This allows you to specify the mode of
serial port2. The available mode selections are:
AWARD BIOS
This
3-33
Advertisement
Table of Contents
