Configure The Sa-G+ To Talk To The Enfora Server - Enfora Quad-Band Spider SA-G+ GSM1308 User Manual

Enfora GSM1308 and GSM1318
Quad-Band Spider® SA-G+
5 Configure the SA-G+ to talk to the
Enfora Server
1. Connect and verify Serial connectivity with the Enfora SA-G+.
With HyperTerminal open, hit the Enter key. The SA-G+ should respond with OK. If
you do not see this response, double-check your connections.
User Guide
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
a. Connect the PC serial connector to the SA-G+ serial port.
Note: In the following instructions, <CR> means using the Enter Key
on the keyboard
b. Type AT<CR>. The SA-G+ should respond with OK. If you do not see
the letters AT, send the following command to the SA-G+: ATE1<CR>
c. Type ATI<CR>. The SA-G+ should respond with Enfora, Inc. If you get
any different response, you are not connected to the Enfora SA-G+.
P a g e 19 Revision: 1.06