Configure The Computer And Verify Correct Communications - Enfora Quad-Band Spider SA-G+ GSM1308 User Manual

Enfora GSM1308 and GSM1318
Quad-Band Spider® SA-G+
4 Configure the Computer and Verify
Correct Communications
1. Default Serial Parameters
2. Determine which Com port to use
User Guide
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Note: The following examples use Windows 2000 and
HyperTerminal. Any Terminal program should work, using the
parameters in Step 1
Autobaud (power up message at115200 baud rate)
8 data bits
1 stop bit
No Parity
Flow Control = None
On older computers, there is usually a built in Com port. This is normally
Com1.
If you are using a USB-to-serial converter, you will need to determine which
Com port it is installed on.
Note: If the USB-to-serial converter has not been installed,
install the necessary drivers per the instruction supplied by
your USB-to-Serial device. Then leave the device
unplugged.
Open up the System Properties window. This is done through the
Control Panel > System or right-click on My Computer and select
Properties. Select the Hardware Tab. On Windows 2000 the screen
looks like the following:
P a g e 13 Revision: 1.06