Installation; Subscriber Identity Module (Sim) Card; Figure 3 - Inserting A Sim Card In A Gsm/Gprs Sa-G+ Module - Enfora Quad-Band Spider SA-G+ GSM1308 User Manual

Enfora GSM1308 and GSM1318
Quad-Band Spider® SA-G+

2 Installation

2.1 SUBSCRIBER IDENTITY MODULE (SIM) CARD

programmed with subscriber information. The user information consists of an
International Mobile Subscriber Identity (IMSI) number, which is registered with the
consists of a microprocessor and memory installed on a plastic card. To install the
SIM card into the modem, insert the SIM card in the modem as shown below in
Figure 3.
Insert the SIM card here
please note that the notch
must be in the upper left
hand corner.
User Guide
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Note: The SIM is not provided with the SA-G+ modem. The
SIM must be obtained from the GSM service provider and must
be provisioned by the operator for data and/or voice. Always
take care to protect the SIM: the GSM terminal will not operate
without the SIM installed.

Figure 3 - Inserting a SIM Card in a GSM/GPRS SA-G+ Module

After inserting the SIM card, you
MUST move the SIM lock switch to
the left. If the lock is open, there
will not be power to the SIM.
P a g e 4 Revision: 1.06