Table 2 8 Pin I/O Connector Interface - Enfora Quad-Band Spider SA-G+ GSM1308 User Manual

Enfora GSM1308 and GSM1318
Quad-Band Spider® SA-G+
During installation take precautions to help ensure proper operation of the SA-G+.
Do not create loops, sharp bends or crimps in the cables. Use proper terminations
on all power cables.
The user can purchase the optional eight (8) pin external I/O connector for the
Enfora SA-G+ that can be used to interface with other devices. Enfora can provide
an optional cable and connector (Part #CAB1308). The user also has the option of
building his/her own cable. Table 2 describes the pin functionality for this 8 pin I/O
connector. Pins that are not planned for usage can be left open without anything
connected to them.
Pin Number
Pin
Pin
Pin
Pin
Pin
Pin
Pin
Pin
User Guide
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Note: If the SA-G+ will be used in a vehicle, attach all cables to the
vehicle and equipment in such a way to reduce stress or wear
caused by vibration generated by moving vehicles.
Functionality
1 Microphone +
2 Headset +
3 Ground
4 Ground
5 Supply Voltage
6 User Controlled IO1
7 User Controlled IO2
8 User Controlled Output

Table 2 8 pin I/O Connector Interface

Description
(6-40V)
(3.3 40V)
Enabler IIIG Module
(3.3 40V)
Enabler IIIG Module
(1.5A sink)
state is latched during a reset.
P a g e 6
Uses GPIO1 of the
Uses GPIO2 of the
Uses GPIO8 of the
Revision: 1.06