Installation - ABB 827E Product Manual

Installation

Equipment Included In Shipment
Included in a shipment of an 827E inverter system are an inverter shelf or shelves (each equipped
with a System Controller and a Distribution Disconnect Module) and inverters and/or blank panels
quantities as specified on the inverter system order.
CAUTION: Loads and Inverters may be damaged if their AC voltages are not matched. Shelves and
Inverters are available for both 120 Vac and 240 Vac applications.
CAUTION: Inverters may be damaged or may not function properly with improper DC input
voltage. Shelves and Inverters are available for both −48 Vdc and +24 Vdc applications.
Verify equipment received before installing the inverter system
• Verify product received matches the order
•
Verify the correct inverter input voltage and output voltage
•
Verify the correct shelf / system input voltage and output voltage
Contact ABB immediately if there is a question about the configuration of the system.
Tools and Test Equipment Required
The tools necessary to install and test the inverter system include items such as a typical Phillips
head screwdriver, torque wrenches, a ratcheting wrench set, wire cutters, a calibrated digital
multimeter, wire crimp tool and die set, etc. No unusual tools are required.
CAUTION: Read this manual thoroughly before attempting to connect, operate, or service an inverter
system. Pay particular attention to these sections:
•
Safety
•
Considerations for Multiple-Shelf Systems
Page 15
© Copyright 2021 ABB. All rights reserved.