Incoming acceptance and product identification
Repair
To ensure continued operational safety and reliability:
‣
Only perform repair work on the device if this is expressly permitted.
‣
Observe federal/national regulations pertaining to the repair of an electrical device.
‣
Use original spare parts and accessories from Endress+Hauser only.
2.5
Product safety
This measuring device is designed in accordance with good engineering practice to meet state-
of-the-art safety requirements, has been tested, and left the factory in a condition in which it
is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC
directives listed in the device-specific EC Declaration of Conformity. Endress+Hauser confirms
this by affixing the CE mark to the device.
3
Incoming acceptance and product identification
3.1
Incoming acceptance
Check the following during goods acceptance:
Are the order codes on the delivery note and the product sticker identical?
Are the goods undamaged?
Do the nameplate data match the ordering information on the delivery note?
If required (see nameplate): Are the Safety Instructions, e. g. XA, provided?
Is the device properly secured?
If one of these conditions is not met, please contact the manufacturer' s sales office.
3.2
Product identification
The measuring device can be identified in the following ways:
• Nameplate data
• Extended order code with breakdown of the device features on the delivery note
• Enter serial number from nameplates in W@M Device Viewer
(www.endress.com/deviceviewer): All the information about the measuring device and an
overview of the Technical Documentation supplied are displayed.
• Enter the serial number on the nameplate into the Endress+Hauser Operations App or use
the Endress+Hauser Operations App to scan the 2-D matrix code (QR Code) on the
nameplate
6
Liquiphant FTL41
Endress+Hauser