Group Operation - Endress+Hauser PROline promag 10 Operating Instructions Manual

11 Description of Device Functions
94
11.3

Group OPERATION

LANGUAGE Use this function to select the language for all texts, parameters and
messages shown on the local display.
Options:
ENGLISH
DEUTSCH
FRANCAIS
ESPANOL
ITALIANO
Factory setting:
Depends on country, see factory setting Page 116 ff.
!
If you press the
"ENGLISH".
ACCESS CODE All data of the measuring system are protected against inadvertent change.
Programming is disabled and the settings cannot be changed until a code is
entered in this function. If you press the
system automatically goes to this function and the prompt to enter the code
appears on the display (when programming is disabled).
You can enable programming by entering your private code (factory
setting = 10, see DEF. PRIVATE CODE function on Page 94)
User input:
Max. 4-digit number: 0...9999
!
• The programming levels are disabled if you do not press a key within 60
• You can also disable programming in this function by entering any number
• The Endress+Hauser service organisation can be of assistance if you
DEF. PRIVATE CODE Use this function to enter a personal code for enabling programming.
User input:
0...9999 (max. 4-digit number)
Factory setting:
10
!
• Programming is always enabled with the code "0".
• Programming has to be enabled before this code can be changed. When
• The function is not available unless the personal code was entered in the
Function description OPERATION
Note!
P
keys simultaneously at startup, the language defaults to
Note!
seconds following automatic return to the HOME position.
(other than the defined private code).
mislay your personal code.
Note!
programming is disabled this function is not available, thus preventing
others from accessing your personal code.
function ACCESS CODE.
PROline Promag 10
P
keys in any function, the measuring
Endress+Hauser