Connecting The Touch Module - BenQ RE6503 User Manual

16
Connections

Connecting the touch module

Connect the TOUCH-USB port on the display to the USB port of a computer using
the supplied USB cable. The touch module of the display supports easy Plug-and-Play
operation. There is no need to install additional drivers on the computer.
• TOUCH 1 must be used with HDMI 1 or VGA.
• HDMI 3 must be used with TOUCH 2 at the front panel.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure
image still exists, use another USB Type-A to Type-A cable.
HDMI 3 TOUCH 2
TOUCH 1
HDMI 1
or
VGA