Connection; Connecting The Vga Input; Connecting The Touch Module - BenQ RP6501K User Manual

Connection

Connecting the VGA input

1. Connect the VGA jack on the display to the VGA output jack on a computer using a
D-Sub (15-pin) cable.
2. Connect the computer's audio output jack to the AUDIO IN jack on the display
with a suitable audio cable.

Connecting the touch module

Connect the TOUCH (type B) jack on the display to the USB port of a computer using
the supplied USB cable. The touch module of the display supports easy Plug-and-Play
operation. There is no need to install additional drivers on the computer.
D-Sub
(15-pin)
cable
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure
image still exists, use another USB type B to A cable.
• TOUCH B port must be connected with HDMI IN 3, DP, or VGA.
HDMI
cable
Audio
cable
DP
cable
USB cable
Computer
Connection 13