Emerson Rosemount 700XA Reference Manual page 56

Table 3: Discrete Digital Inputs TB7
TB7 Function
Pin 1 DI1
Pin 2 DI-RTN
Pin 3 DI2
Pin 4 DI-RTN
Pin 5 DI3
Pin 6 DI-RTN
Pin 7 DI4
Pin 8 DI-RTN
Pin 9 DI5
Pin 10 DI-RTN
Wire a ROC800 digital input (DI) module
To connect the ROC800 DI module to a field device, do the following:
Procedure
1. Expose the end of the wire to a maximum length of ¼-in. (6.4 mm).
Note
Twisted-pair cables are recommended for in/out (I/O) signal wiring. The module's terminal blocks accept wire sizes between
12 and 22 American wire gauge (AWG). Allow some slack when making connections to prevent strain.
CAUTION
Failure to follow this precaution may cause a short circuit and damage equipment.
Allow only a minimum exposure of bare wires to prevent short circuits.
2. Insert the exposed end into the clamp beneath the termination screw.
3. Tighten the screw.
56
July 2020
Emerson.com/Rosemount