Set One-Touch Patrol; Set Pattern Scan - HIKVISION DS-2SE7C43C432MW-AEB User Manual

It is the duration staying on one patrol point.
Delete the presets in patrol.
Adjust the preset order.
Note
A patrol can be configured with 32 presets at most, and 2 presets at least.
4. Click OK to finish a patrol setting.
5. Repeat the steps above to configure multiple patrols.
6. Operate patrols.
Call the patrol.
Stop patroling.
Delete the patrol.
Set the patrol.
Note
You can delete all patrols in Configuration → PTZ → Clear Config . Click Clear All Patrols, and
click Save.

4.3.1 Set One-Touch Patrol

The device automatically adds presets to one patrol path and starts patrol scan.
Steps
1. Set two or more presets among preset No.1 to preset No.32. For setting presets, refer to Set
Preset .
The device will automatically add presets to patrol path No.8.
2. Choose one of the following methods to enable the function.
- Click .
- Call patrol path No.8.
- Select and call preset No.45.

4.4 Set Pattern Scan

The device can move as the recorded pattern.
Steps
1. Click to show the PTZ control panel, and click
2. Select one pattern scan path that needs to be set.
3. Click to start recording pattern scan.
4. Click PTZ control buttons as demands.
TandemVu PTZ Camera User Manual
.
19