Send Email - HIKVISION DS-2SE7C43C432MW-AEB User Manual

Refer to Set FTP to set the FTP server.
Refer to Set NAS for NAS configuration.
Refer to Set New or Unencrypted Memory Card for memory card storage configuration.

9.2.3 Send Email

Check Send Email, and the device sends an email to the designated addresses with alarm
information when an alarm event is detected.
For email settings, refer to Set Email .
Set Email
When the email is configured and Send Email is enabled as a linkage method, the device sends an
email notification to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email function. Go to Configuration → Network → Basic
Settings → TCP/IP for DNS settings.
Steps
1. Go to email settings page: Configuration → Network → Advanced Settings → Email .
2. Set email parameters.
1) Input the sender's email information, including the Sender's Address, SMTP Server, and
SMTP Port.
2) Optional: If your email server requires authentication, check Authentication and input your
user name and password to log in to the server.
3) Set the E-mail Encryption.
When you select TLS, and disable STARTTLS, emails are sent after encrypted by TLS. The
●
SMTP port should be set as 465.
When you select TLS and Enable STARTTLS, emails are sent after encrypted by STARTTLS,
●
and the SMTP port should be set as 25.
Note
If you want to use STARTTLS, make sure that the protocol is supported by your email server.
If you check the Enable STARTTLS while the protocol is not supported by your email sever,
your email is sent with no encryption.
4) Optional: If you want to receive notification with alarm pictures, check Attached Image. The
notification email has 3 attached alarm pictures about the event with configurable image
capturing interval.
5) Input the receiver's information, including the receiver's name and address.
6) Click Test to see if the function is well configured.
3. Click Save.
TandemVu PTZ Camera User Manual
70