Table of Contents
Advertisement
Attention!
This interface will work with models that are either factory amplified, or
non-amplified. Please follow the instructions carefully for your model vehicle. Failure
to do so will result in either no sound, or low sound. If you are unsure if your vehicle
is factory amplified or not, please contact your local dealership.
For models with an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an AX-LCD (sold separately), there will be an accessory wire
there to connect as well.
• Connect the Blue/White wire to the amp turn on wire. This wire must be
connected to hear sound from the factory amplifier, and also for the audio
controls on the steering wheel to function.
• If the aftermarket radio has an illumination wire, connect the Orange/White
wire to it.
• If the aftermarket radio has a mute wire, connect the Brown wire to it. If the
mute wire is not connected, the radio will turn off when OnStar is activated.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
AX-GMLAN11-SWC
Connections to be made
The following (3) wires are only for multimedia/navigation radios that require these wires.
3
®
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (4) wires, they will not be used in this
application: Green, Green/Black, Purple, Purple/Black
From the AX-GMLAN11-SWC harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Disconnect the (2) 4-pin Molex connectors, and then attach the 4-pin to 4-pin
resistor pad harness.
• The Black/Yellow wire is used for OnStar level adjustment for models that
do not come equipped with steering wheel controls. Refer to the OnStar level
Adjustment section for further instructions.
•
Connect the Red and White RCA jacks to the audio AUX-IN jacks of the aftermarket radio
• The DIN jack is to be used with the optional AX-LCD (sold separately).
• Connect the Red wire to accessory power.
Continue to 3.5mm jack steering wheel control retention
.
Advertisement
Table of Contents
