1. Manuals
  2. Brands
  3. Axxess Manuals
  4. Automobile Accessories
  5. AXDIS-GMLN30
  6. Installation instructions manual

Axxess AXDIS-GMLN30 Installation Instructions Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
INTERFACE COMPONENTS
• AXDIS-GMLN30 interface • AXDIS-GMLN30 harness
• 16-pin harness with stripped leads
• Female 3.5mm connector with stripped leads
APPLICATIONS
Chevrolet
Blazer (IOT, IOU) **
2019-Up
Camaro (IOS, IOT) **
2019-Up
Cheyenne (IOS, IOT) **
2019-Up
Colorado (IOS, IOT)
2019-Up
** For extension, use AXEXH-GM30
AxxessInterfaces.com
GM Data Interface with SWC
INTERFACE FEATURES
• Provides accessory power
(12-volt 10-amp)
• Retains R.A.P. (retained
accessory power)
• Provides NAV outputs (parking
brake, reverse, speed sense)
Equinox (IOS, IOT) **
2019-Up
Malibu (IOU, IOS) **
2019-Up
Silverado (IOS, IOT) **
2019-Up
Volt
2019-Up
© COPYRIGHT 2021 METRA ELECTRONICS CORPORATION
2019-Up
• Retains audio controls on the
steering wheel
• Non-amplified models only
• Retains balance and fade
• Micro-B USB updatable
GMC
Acadia (IOU) **
2019-Up
Canyon (IOS, IOT)
2019-Up
Sierra 1500 (IOS, IOT) **
2019-Up
Terrain (IOS, IOT, IOU) **
2019-Up
AXDIS-GMLN30
I N S TA L L AT I O N I N S T R U C T I O N S

TABLE OF CONTENTS

Connections to be made ....................................2-3
Installing the AXDIS-GMLN30 ................................3
Programming the AXDIS-GMLN30 ........................4
Steering wheel control settings ........................5-7
- L.E.D. feedback ....................................................5
- Changing radio type ...........................................5
- Dual assignment instructions ............................7
Troubleshooting .....................................................8
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell
caps, etc.) • Small flat-blade screwdriver
Product Info
REV. 3/17/21 INSTAXDIS-GMLN30

Advertisement

Table of Contents
loading

Related Manuals for Axxess AXDIS-GMLN30

Summary of Contents for Axxess AXDIS-GMLN30

  • Page 1: Table Of Contents

    - Dual assignment instructions ......7 Troubleshooting .............8 INTERFACE COMPONENTS TOOLS REQUIRED • AXDIS-GMLN30 interface • AXDIS-GMLN30 harness • 16-pin harness with stripped leads • Wire cutter • Crimp tool • Solder gun • Tape • Connectors (example: butt-connectors, bell • Female 3.5mm connector with stripped leads caps, etc.) •...

  • Page 2: Connections To Be Made

    CONNECTIONS TO BE MADE From the 16-pin harness with stripped leads to the aftermarket radio: From the AXDIS-GMLN30 harness to the aftermarket radio: • Connect the Red wire to the accessory wire. • Connect the Black wire to the ground wire.

  • Page 3: Mm Jack Steering Wheel Control Retention

    For the radios listed below, connect the included female 3.5mm connector with stripped leads, to the male 3.5mm SWC jack from the AXDIS-GMLN30 harness. Any remaining wires tape off and disregard. Attention! Do not connect the AXDIS-GMLN30 harness to the wiring harness in the vehicle just yet. •...

  • Page 4: Programming The Axdis-Gmln30

    L.E.D. • Start the vehicle. • Connect the AXDIS-GMLN30 harness to the wiring harness in the vehicle. • The L.E.D. will initially turn on solid Green, then turn off for a few seconds while it auto detects the radio installed.

  • Page 5: Steering Wheel Control Settings

    * Note: If the AXDIS-GMLN30 flashes Red (7) times, and you do not have an Alpine radio connected 5. Once the desired radio number has been selected, press and hold the Volume-Down button to it, that means the AXDIS-GMLN30 does not detect a radio connected it.

  • Page 6: Remapping The Steering Wheel Control Buttons

    (1) second until the L.E.D. comes on, and then release the Volume-Up button. This 1. Eclipse (Type 1) 7. Alpine 13. LG will tell the AXDIS-GMLN30 that this function is not available and it will move on to the next 2. Kenwood 8. Visteon 14. Parrot function.

  • Page 7: Dual Assignment Instructions

    STEERING WHEEL CONTROL SETTINGS (CONT) Dual assignment instructions (long button press) Dual assignment legend The AXDIS-GMLN30 has the capability to assign (2) functions to a single button, except Volume- 1. Not allowed 6. ATT/Mute 11. Play/Enter 15. Fan-Up * Up and Volume-Down. Follow the steps below to program the button(s) to your liking.

  • Page 8: Troubleshooting

    Having difficulties? We’re here to help. TROUBLESHOOTING Contact our Tech Support line at: 386-257-1187 Resetting the AXDIS-GMLN30 Or via email at: techsupport@metra-autosound.com 1. The Blue reset button is located inside the interface, between the two connectors. The button is accessible outside the interface, no need to open the interface.

Table of Contents