Status Light Indicators & Warnings; Transmitter Status Light Indication - Magnetek Enrange Flex EX Instruction Manual

B. Status Light Indicators & Warnings

1. Transmitter STATUS Light Indication

Type
1
1 red blink followed by a 2-
2
2 red blinks followed by a 2-
3
4
3 red blinks followed by a 2-
5
4 red blinks followed by a 2-
6
Constant green for up to 2
7
8
9
Display Type
Constant red
second pause
second pause
No light displayed
second pause
second pause
seconds
Blinking green
Blinking orange
Indication
Voltage below 1.9V at initial power on,
transmitter power and receiver MAIN shuts off.
Voltage below 1.8V during operation,
transmitter power and receiver MAIN shuts off.
Voltage goes below 1.85V during operation -
change batteries immediately.
The push button is defective after turning on the
transmitter power.
When a defective push button condition occurs
(2 red blinks, type 3 above), find out which push
button is defective by pressing all the push
buttons on the transmitter one at a time. If the
push button is in good working order, the LED
will not light up when pressed. If the push
button is defective the LED will continue to
display 2 red blinks when pressed.
EEPROM error.
Transmitting error; system can not lock on
to the designated channel.
Transmitter power on with no faults detected
Transmission in progress.
Transmitter push button functions locked.
Flex 8EX EU System Instruction Manual
March 2012
33 of 37