Mitsubishi Heavy Industries SCM71ZM-S1 Technical Manual page 327

④
Wireless remote control
Installation tips for the remote control holder
Fix the remote control holder using the screws supplied
with this product.
* Precautions for installing the holder
● Adjust the position so that it is upright.
● Ensure that the screw heads are not protruding.
● Do not attach the holder on plaster wall
How to insert batteries
1. Detach the back lid.
2. Insert the batteries. (two AAA batteries)
3. Reattach the back lid.
Setting to avoid mixed communication
1. Detach the back lid, and remove the batteries.
2. Cut off the switching wire in the battery compartment using nippers.
3. Insert the batteries, and attach the back lid.
Changing the wireless remote control setting
How to change the Auto Run setting
The Auto Run mode is not available on the building air-conditioner and gas heat
pump series (excluding the cooling/heating free multi system).
When using the wireless remote control to operate those models, set the wireless
remote control to disable the Auto Run mode.
To disable the Auto Run mode, press the ACL switch while holding down the MODE
button, or insert batteries while holding down the MODE button.
* Note: Once the batteries are removed, the setting is reset to the factory default.
When the batteries are removed, repeat the steps described above.
Indoor function settings
1. How to set indoor functions
① Press the ON/OFF button to stop the unit.
② Press the desired one of the buttons shown item 2. while holding down the
FUNCTION SETTING switch.
③ Use the selection buttons, ▲ and ▼, to change the setting.
④ Press the SET button.
The buzzer on the wireless remote control signal receiver beeps twice, and
the LED lamp flashes four times at two-second intervals.
⑤
Receiver
1 Control plural indoor units with one remote control
Up to 16 indoor units can be connected.
Wood screw
Ensure the correct
polarity when
inserting.
326
- -
Restrictions on the thickness and length of wire
(Maximun total extension 600m.)
'17 • SCM-T-225
Holder for
remote control
Cutting
Auto Run setting
③
④
④
W
2. Se
Th
B t u
FAN S
MODE
FILTE
U/P
(Up/Do
SILEN
HI PO
ON TI
OFF T
NIGHT
SETBA
* Refer
①
④
5
⑤
R
Wire