Table 20 Abnormal Alarm Parameters
Parameter
Enable abnormal events
Abnormal type
Event actions
1. Click APPLY to complete settings.
Alarm Out
The external alarm device is connected to the alarm out port.
1. Go to Main Menu > Event > Alarm out.
The Alarm Out interface is displayed.
Figure 72 Alarm Out
2. Configure parameters.
Table 21 Alarm Out Parameters
Parameter
Port number
Port name
Valid signal
Alarm output mode
3. Click APPLY to complete settings.
Honeywell 35 Series Network Video Recorder User Guide
Description
Check the box
to enable the function.
Disk alarm, IP address conflict, network disconnect
Enable different event actions
Description
Correspond to real panel I/O port OUT 1
Input the port name. The name will show on the alarm information
message.
Close: An alarm is generated when an external alarm signal is
received.
Open: An alarm is generated when no external alarm signal is
received.
When the device receives I/O alarm signals, the device sends the
alarm information to an external alarm device
59