Technical Data - Gira System 3000 Operating Instructions Manual

System 3000
Touch top unit
8 Information for electrically skilled persons
DANGER!
Mortal danger of electric shock.
Disconnect the device. Cover up live parts.
Fitting the device
￭ Switching, dimming or Venetian blind insert or 3-wire extension are mounted and connec-
ted properly (see instructions of the relevant inserts).
￭ Fit the cover with frame on the insert.
￭ Switch on mains voltage.
If the status indication flashes repeatedly in the middle three times, the top unit was previously
connected to an insert of another unit. In order to enable operation again either attach the top
unit to the correct insert or simultaneously press surfaces (1) and (3) for longer than 4 seconds.
The top unit then has the factory settings.
8.1 Commissioning
Venetian blinds and shutters
So that a blind/shutter position can be approached correctly, the running time and also with
Venetian blinds the slat adjusting time must be saved. This happens on the main device, see
chapter Operation of Venetian blinds and shutters
A fan position is also saved on the main device. This can be saved again at any time and does
not have to happen during commissioning.
Lighting
No commissioning is necessary on the touch top unit. New brightness values for the buttons (1)
to (3) can be saved to the main device at any time, see chapter Operation of lighting.
9

Technical data

Ambient temperature
Storage/transport temperature
Data according to EN 60730-1
Action
Degree of soiling
Measured surge voltage
10 Warranty
The warranty is provided in accordance with statutory requirements via the specialist trade.
Please submit or send faulty devices postage paid together with an error description to your re-
sponsible salesperson (specialist trade/installation company/electrical specialist trade). They will
forward the devices to the Gira Service Center.
32403002 10867543 21.10.2020
-5 ... +45 °C
-20 ... +70 °C
1.B
2
4000 V
7 / 8