Table of Contents
Advertisement
Set the electricity level of the IR LED.
The N/M LED CURRENT and the FAR LED CURRENT refer to the electricity level of the
near/middle IR LED and far IR LED correspondingly.
Set the parameters for reference zoom.
The value of REFERENCE ZOOM can be adjusted from 2 to 10.
Set the parameters of LED control.
LED control can be set to ALL ON (enable all the IR LED), FAR ON (enable far-distance IR LED),
NEAR ON (enable near/medium-distance IR LED), AUTO (enable IR LED automatically according
to the environment illumination), ICR (adjust the IR LED working mode according to the ICR),
and CLOSE (disable IR LED).
Set the IR LED switch delay.
The SWITCH DELAY(S) refers to the delay time between the switch of far-distance IR LED and
N/M-distance IR LED.
Set smart IR.
The brightness of IR automatically changes according to the focal length. The greater the value,
the more obvious the brightness changed.
3.4 Configuring PTZ Control Parameters
Purpose:
You can adjust panning, tilting and zooming movements, and also PTZ control functions including
presets, patrols, patterns, etc. of the speed dome.
3.4.1 Configuring PTZ Parameters
Enter PTZ configuration menu:
MAIN MENUS > SYS SETTINGS > MOTION PARAMETER
Auto-flip
In manual tracking mode, when a target object goes directly beneath the speed dome, the speed
dome automatically rotates 180 degrees horizontally for tracking.
AUTO-FLIP is set to ON by defaulted and it is not user-definable.
HD-TVI Speed Dome User Manual
MOTION
AUTO FLIP
ON
PROPORTIONAL PAN
ON
PARK TIME
5
PARK ACT
NONE
SCAN SPEED
28
IMAGE FREEZE
OFF
MOVE SPEED
6
BACK
EXIT
Figure 3-11 PTZ Configuration
21
Advertisement
Table of Contents
