Configuring Presets - HIKVISION DS-2AE4215T-D User Manual

Steps:
1. Move the cursor to ENABLE LIMIT and click FOCUS+ to set it ON to enable this feature. Click
IRIS+ to confirm the new settings.
2. Move the cursor to SETTING STOPS and click IRIS+. You will see the message SET LEFT LIMIT on
the screen.
3. Click the direction buttons in the PTZ panel to configure the left limit. Click IRIS+ to confirm the
new settings.
4. Follow the prompts to configure the right, up and down limits on the menu.
The new limit will overwrite the existed ones by defaulted.
5. You can clear the defined limits. Click IRIS+ to enter CLEAR LIMITS and click IRIS+ again to clear
the stops.
 Elevation set
You can set the SET ELEVATION to ON to increase the elevation angle range of the speed dome or
set it to OFF to disable the function.

3.4.2 Configuring Presets

Purpose:
A preset is a user-defined monitoring position/point. You can simply call the preset number to
change the monitor scene to the defined position.
Steps:
1. Move the cursor to enter preset configuration submenu:
MAIN MENUS > SYS SETTINGS > PRESETS
2. Choose the preset number:
Move the cursor to PRESET NUM. and click IRIS+ to enter. Click the up and down buttons to
choose the preset number which needs to be edited. If the preset has been defined, the preset
label will be listed under the number; if it has not been defined, you will see the information
UNDEFINED under the number.
HD-TVI Speed Dome User Manual
Figure 3-12 Preset Configuration Menu
23