Chapter 2 Getting Started; Power-Up Action; Basic Operations - HIKVISION DS-2AE4215T-D User Manual

2.1 Power-up Action

After the speed dome is power-on, it will perform a series of self-test actions. The interface will be
shown as below:
SN
ADDRESS
COM MODE
PROTOCOL
FIRMWARE
HARDWARE
BUILD DATE
 You have to configure the address and the baud rate for the speed dome the same as those in
the control devices.
 The speed dome is self-adaptive to the PELCO-D, PELCO-P, and PRIVATE-Code protocols.

2.2 Basic Operations

You can operate the speed dome by using a control device, including the control keyboard, DVR,
DVS, etc. In this manual, accessing the speed dome via the web browser will be taken as the
example.
HD-TVI Speed Dome User Manual

Chapter 2 Getting Started

Figure 2-1 Original Interface
Table 2-1 Descriptions of the original interface
The serial No. of the speed dome, which is unique.
The default communication address of the speed dome.
The communication settings of the speed dome, including baud rate
(2400 by default), data bit (8 by default) and stop bit (1 by default)
digit).
It is for the communication with other devices.
The version of the firmware.
The version of the hardware.
The date when the program of the software is compiled.
4