Seco i-PAN7 Manual page 2

Interfaces / Signals accessible over extension connectors:
10/100 MBit Ethernet
2 x USB Host
USB Slave
I2C
1
SD/MMC Card
2
RS232 COM1 FF_UART
3
RS232 COM2 BT_UART (if GSM not used
5
COM3 STD_UART (if GPS not used
RS485 (instead of COM2 BT_UART
Audio out
Mic input (mono) for electret-capacitor microphones
3 x 10 bit ADC
IrDA
Programmable input and output pins (CPLD)
CAN bus
▪ Please do not use the card socket on i-PAN7 and Connector Board at same time! This can
cause data loss on the memory card!
▪ level converter: 24V
▪ level converter: 24V
▪ if mounted modem uses COM2 for communication with CPU
▪ CPU signals: 3,3V
▪ if mounted GPS module uses COM3 for communication with CPU
▪ customer can choose between RS232 or RS485, see also note 3
Version 2.0
4
)
6
)
7
)
i-PAN7 2 of 14