Power Supply - Seco i-PAN7 Manual

4 POWER SUPPLY

The i-PAN7 needs a nominal power supply of 12 Volt. The device will work stable in a power
range of 7 ... 24 Volt. Applying a voltage more than 24 Volt will damage electronic components.
Usually connector J13 is equiped. The polarity is shown in figure 4.
FIGURE 4.
Polarity of J13
center pin diameter : 1.65mm, input hole diameter : 4.40mm
For a more ruggedized system or a rough industrial surrounding i-PAN7 can be pro- vided with an
alternative power connector (J25, see table 1).
Power consumption @ 12V
i-PAN7 LC, idle, full backlight: 340 mA
i-PAN7 LC, idle, normal backlight: 240 mA
Suspend current @ 12V
i-PAN7 LC with Ethernet: 20,5 mA i-PAN7 LC no Ethernet: 2,8 mA
Version 2.0 i-PAN7 9 of 14