Advertisement
Quick Links
Advertisement
Related Manuals for ZKTeco LH3600
Summary of Contents for ZKTeco LH3600
- Page 1 Installation Instruction LH3600...
-
Page 2: Before Installation
Before Installation Diagram... -
Page 3: Packing List
Packing List 55 mm 40 mm 20 mm 105mm 65 mm... -
Page 4: Door Preparation
Door Preparation 1. Check door thickness, prepare the proper screws and spindles. Door Thickness D Spindle K Spindle M Screw N Screw 35~55 mm 40 mm 105 mm 55 mm 65 mm Note: If out of the door thickness of 35-55 mm,this lock will not be available. 2. - Page 5 Cautions 1. New lock is defined as always open mode until it was unlocked once by mifare card. 2. Please swipe authorised card, time sync card, room card at first for the new lock. 3. The lock is equipped with mechanical keys for manual unlocking. Remove the mechanical keys from the package and keep them in a safe place.
-
Page 6: Installation
Installation 1. Drill holes on the door 2. Remove the mortise latch plate (G) center line of the handle Note 1: Align the template along the vertical center line of the mortise (E) at the desired handle height, and tape it to door. Note 2: Mark the holes first, then start drilling. - Page 7 3. Install mortise (E) 4. Install mortise latch plate (G) Note: Ensure the two triangles are in horizontal alignment.
- Page 8 6.Install outdoor unit (C) 5. Install spindle (D)
- Page 9 8. Install indoor unit (L) 7. Install spindle (D) and (K)
- Page 10 9.Install the battery (O)
- Page 11 10.Mark and drill holes for strike 25 mm...
- Page 12 11. Test Lock by mechanical key (A) Step1: Remove the cover on the key hole with sucker (B). Step2: Insert mechanical key (A) into the key hole and rotate it at 90°. Step1 Step2...