Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ZKTeco LH6000
Summary of Contents for ZKTeco LH6000
- Page 1 Installation Instruction LH6000 Version: 1.1 Date: Apr. 2018...
-
Page 2: Before Installation
Before Installation Lock Diagram... -
Page 3: Packing List
Packing List 40 mm 20 mm 75 mm 75mm... -
Page 4: Door Preparation
Door Preparation 1. Check door thickness; prepare proper screws and spindles. Door Thickness F Spindles O Screws Q Spindle 35-55 mm 40 mm 75 mm 75 mm Note: If the door is thicker than 35-55 mm,this lock will not be available. 2. - Page 5 Cautions 1. New lock is defined as always open mode until it was unlocked once by mifare card. 2. Please swipe authorised card,time sync card,room card at first for the new lock. 3. The lock is equipped with mechanical keys for manual unlocking. Remove the mechanical keys from the package and keep them in a safe place.
-
Page 6: Installation
Installation 1. Drill holes on the door 2. Remove the mortise latch plate (G) center line of the handle backset 62.5 mm Note 1: Align the template along the vertical center line of the mortise (G) at the desired handle height, and tape it to door. Note 2: Mark the holes first, then start drilling. - Page 7 3. Install mortise (G)
- Page 8 4. Install lock cylinder (E) 5.Install spindle (F) Note: Ensure the two triangles are in horizontal alignment.
- Page 9 6.Install outdoor unit (D) 7.Install spindle (F) and (O) and key cover(C)
- Page 10 9.Install the battery (T ) and 8.Install indoor unit (P) battery cover (R)
- Page 11 10. Mark and drill holes for strike 25 mm...
- Page 12 11. Test Lock by mechanical key (B) Step1: Remove the cover on the key hole with a sucker(A). Step2: Insert mechanical key (B) into the key hole and rotate it at 90°.