Door Preparation 1. Check door thickness, prepare the proper screws and spindles. Door Thickness D Spindle L Screw M Screw O Screw E Cylinder 45-60 mm 40 mm 55 mm 40 mm 50 mm 60-75 mm 55 mm 70 mm 15 mm 50 mm 75-90 mm...
Page 5
2. Check door open direction. Left inward Right inward Left outward Right outward Note : 1. Mortise (F) can be applied to inward or outward directions by adjusting the direction of latch bolt. Please refer to Tips for further details. 2.
Page 6
Tips 1. How to change the direction of latch bolt? 180° Step1: Press the end of latch bolt as the direction of arrow 1. Step2: Rotate the latch bolt at 180°, which is shown as arrow 2. 2. How to change the handle direction? Front Panel Back Panel Loose...
Page 7
3. How to use mechanical key ? 4. How to use emergency power? Press the cover on key hole Insert the key into key hole and contrarotate it at 30° to and rotate it. 9V Battery remove the cover. Cautions 1.
Installation 1. Drill holes on the door 2. Install the mortise (F) door thickness 45~90 mm center line of the handle desired handle height Backset 60 mm Note 1: Align the template along the vertical center line of the mortise (F) at the desired handle height, and tape it to door.
Page 9
4.Install spindle (D) 3.Install lock cylinder (E) Note: Install lock cylinder in right direction, then tighten screw (H) to fix it.
Page 10
5.Install outdoor unit (B) with gasket (C)
Page 11
6. Install mounting plate (K) with 7. Install spindle (D) on the door gasket (C) on the door...
Page 12
8. Install indoor unit (N) 9. Install the battery (P) Note: Push cable into the hole .
Page 13
10.Mark and drill holes for strike 36 mm 10 mm 7 mm 11.Test the lock by mechanical key (A) or registered fingerprint...