Advertisement
Quick Links
Advertisement
Related Manuals for ZKTeco LH7000
Summary of Contents for ZKTeco LH7000
- Page 1 Installation Guide LH7000 Version: 1.0 Date: Jan. 2019...
-
Page 2: Before Installation
Before Installation Lock Diagram... -
Page 3: Packing List
Packing List... - Page 4 Preparing Door 1. Check door thickness; prepare proper screws and spindles. Door Thickness D Spindles C Spindle F Screws 38 - 48 mm 40 mm 75 mm 25 mm Note: If the door is thicker than 38-48 mm, this lock will not be available. 2.
- Page 5 Cautions 1. New lock is defined as always open mode until it was unlocked once by mifare card. 2. Please swipe authorised card, time sync card, room card at first for the new lock. 3. The lock is equipped with mechanical keys for manual unlocking. Remove the mechanical keys from the package and keep them in a safe place.
-
Page 6: Installation
Installation 1. Drill holes on the door 2. Remove the mortise latch plate (J) center line of the handle backset 54 mm Note 1: Align the template along the vertical center line of the mortise (E) at the desired handle height, and tape it to door. Note 2: Mark the holes first, then start drilling. - Page 7 3. Install mortise(E) 4.Install cylinder(G) and fix the mortise(E)
- Page 8 5. Install coil spring(B) exterior panel A interior panel N...
- Page 9 6.Install spindle (D) and 7.Install spindle (C) and (D) exterior panel (A)
- Page 10 8.Install interior panel 9. Install the battery (P) and plastic cover (M)
- Page 11 10.Mark and drill holes for strike 21 mm...
- Page 12 11. Test Lock by mechanical key (S) Step1: Remove the cover on the key hole with a sucker( T ). Step2: Insert mechanical key (S) into the key hole and rotate it at 90°.