ZKTeco PL10 Installation Manual
Fingerprint lock
Hide thumbs
Also See for PL10:
- User manual (16 pages) ,
- Installation instruction (10 pages) ,
- User manual (15 pages)
Related Manuals for ZKTeco PL10
Summary of Contents for ZKTeco PL10
- Page 1 Installation Instruction PL10/ML10 Version: 1.0 Date: Dec., 2014...
- Page 2 Before Installation Diagram...
- Page 3 Packing List Mounting Hardware Package Mounting Hardware Package 39-46mm door thickness 47-54mm door thickness 64mm 7 2mm 35mm 40mm 30mm 35mm...
-
Page 4: Door Preparation
Door Preparation 1. Check door thickness and prepare the mounting hardware package. Door Thickness H Spindle Length J Screw Length M Screw Length L Screw Length (mm) (mm) (mm) (mm) (mm) 30~38 39~46 47~54 55~60 Note: The standard lock includes 2 mounting hardware package only, which is used for the door thickness of 39-46mm and 47-54 mm separately. - Page 5 3. Check the required backset (60mm or 70mm). 70mm 60mm Note2: The latch has TWO backset options: 60mm or Note1: Installation template has the backset options of both 60mm and 70mm. 70mm, please adjust it by yourself.
- Page 6 Cautions 1. New lock is configured to grant ANY fingerprint access to unlock. 2. The lock is equipped with mechanical keys for manual unlocking. Remove mechanical keys from the package and keep them in a safe place. 3. To power on the lock, four alkaline AA batteries (not included) are required. Non-alkaline and rechargeable batteries ARE NOT RECOMMENDED.
- Page 7 Installation 1. Drilling holes on the door. 2.Install the latch (D). center line of the handle desired handle height Note1: Align the template along the vertical center line of the latch(D) at the desired handle height, and tape it to the door. Note2: Mark the holes first, then start drilling.
- Page 8 3.Install outdoor unit(B) with gasket(C) and spindle(H) on the door. Correct Position: T he small triangle must be vertically upward. This position is W rong !
- Page 9 4.Install mounting plate (I) with gasket (C) on the door. 5.Install indoor unit (K). Note : Push cable into the hole.
- Page 10 6. Install the battery. 7.Mark and drill holes for strike. (5/64") 12mm (15/32" 21mm (53/64") 35mm (35/64") (1-3/8") 8. Testing the lock by rotating back handle and using mechanical key(A). Note : When the door is l ocked, the clutch is in idle position, the front handle will be turned.