LifeSpan Pursuit 3 User Manual page 27

Code
E06
E07
E08
E09
E10
E12
Reason
Motor open-phase protection
Motor lock-up protection
Motor doesn't work
Motor over current protection
Overload protection
Communication failure
Solution
1. Check whether the motor wiring is
normal, if it is normal, replace the
control board
2. Change the motor.
1. It is overload, or the motor/
rollers are stuck. Check whether
the transmission parts are normal.
Turn off the switch and restart the
machine.
1. The motor/drum is stuck. Check
whether the transmission parts are
normal.
2. Replace the lower control or motor.
1. The machine is being used too long,
the friction is high, put some silicon
oil under running belt according to
instruction.
2. Replace the motor.
1. The machine is being used too long,
the friction is high, put some silicon
oil under running belt according to
instruction.
2. Replace the motor (within the rated
load).
1. Check if the computer top and
bottom wire are properly connected
and without damage. If not,
reconnect the wire or change the
broken computer top and bottom
wire.
2. Check if the control board
communication interface is normal.
3. Change the control board.
4. Check if the computer
communication interface is normal.
5. Change the computer.
TROUBLE SHOOTING GUIDE | 27