Flashforge Guider 3 User Manual page 5

Hide thumbs Also See for Guider 3:

Table of Contents

Any modification of the equipment by yourself will result in the situation that you will

not be entitled to warranty rights anymore.

Please keep the distance between the extruder and build plate for at least 50mm

during filament loading. Too-close distance may cause nozzle clogging.

Please operate the equipment in a well-ventilated environment.

Do not use the equipment for illegal activities.

Do not use the equipment to make any food storage products.

Do not put the printed model into your mouth.

EQUIPMENT ENVIRONMENT REQUIREMENTS

The room temperature should be between 15℃ and 30℃.

The humidity should be between 20RH% and 70RH%.

EQUIPMENT PLACEMENT REQUIREMENTS

The equipment must be placed in a dry and ventilated environment. A distance of at

least 30cm must be reserved at the left side and rear side of the equipment, and a

distance of at least 45cm must be reserved at the right side and front side of the

equipment.The storage temperature should be between 0℃ and 40℃.

COMPATIBLE FILAMENT REQUIREMENTS

When using the equipment, it is recommended to use Flashforge's filaments.

If non-Flashforge filaments are used, there will be certain differences in material

characteristics, and thus printing parameters may need to be adjusted.

FILAMENT STORAGE REQUIREMENTS

Please store filaments in a dry and dust-free environment after unpacking. It is

recommended to use the matching filament dry box for storage.

LEGAL STATEMENT

The user has no right to make any modification to this user guide.

Flashforge will not be responsible for any safety accidents caused by the disassembly

or modification of the equipment by the customer. No one is allowed to modify or

translate this guide without the permission of Flashforge. This guide is protected by

First Edition (August 2022)

Table of Contents