Table of Contents
Advertisement
Printer Name
Language
Air
Platform Temp
Led
The several functions can be turned on or off on the settings screen.
When the Air is turned on, the fan on the back of the equipment will be started; The
front of the fan is equipped with HEPA filter cotton, which can filter the dust and odor
generated during printing.
When the Platform Temp is turned on, the platform insulation time before and after
printing can be set. When in the transition state of removing the model, avoid
increasing the time of reheating when the temperature drops. When this function is
turned on, the platform remains the heating state when removing the model after
finishing printing. Please pay attention to the high temperature and preventing burns
and scalds.
When the Led is turned on, the brightness of the light inside the chamber can be
adjusted.
When the Detect Filament is turned on, the equipment will stop printing when the
filament runs out during printing.
When the Recover Print is turned on, if the device encounters a power failure during
printing, the device will automatically store the current printing position data. Then it
will proceed the printing of the current model after the power is restored.
When the Power Off is turned on, the equipment will automatically shut down after
finishing model printing.
5.5 Settings Screen
Guider 3 >
English >
Open >
5 min >
Open >
18
Detect Filament
Recover Print
Power Off
Screen Light
Factory Reset
85% >
>
Advertisement
Table of Contents
