User Operating Procedures - AERMEC PGD1 User Manual

1.4 USER OPERATING PROCEDURES

To check or modify the operating parameters of the unit it is necessary to use the
interface of the control panel on the unit.
The basic operations that the user must be capable of, for the correct use of the
unit, are:
— Moving between menus;
— Selecting and modifying a menu.
Moving between menus
To move between the menus, the order in which they are displayed is shown in the
previous page, enter the menu selection mode by pressing the key
Once in the menu selection mode it is possible to move between menus using the
arrow keys: the key to move to the previous menu, and the key
to the next menu:
When the desired menu is seen press the key
to return to the menu selection mode:
Selecting and modifying a menu
Once in the menu selected, by following the procedure, it is possible to move be-
tween the screens using the arrow keys: the key
rameter, and the key to move to the next parameter:
;
to move
to enter the menu. Press the key
to move to the previous pa-
When the desired parameter is seen press the key
exit the parameter and return to the parameter selection mode press the key
WARNING: Once a parameter is selected by pressing the key
rameter selection mode is automatically accessed.
In this mode the desired parameter values can be set with the following procedure:
1. Pressing the key causes a flashing cursor to appear on the first modifiable
field of the parameter. If no modifiable fields are displayed then the cursor will
not appear.
2. Pressing the key or the key
or decreased;
3. Pressing the key confirms the modification of the field value, saving it in
memory.

Note: On the basis of the type of parameter selected the number of modifiable fields
can change.
to enter the parameter. To
, the pa-
, the value of the field can be increased
.
7