Storage Drives - Supermicro SuperServer SYS-510D-4C-FN6P User Manual

3.5 Storage Drives

The system supports four internal 2.5" solid-state disk drives.
Note: Enterprise level drives are recommended for use in Supermicro servers. For information
on recommended HDDs, visit the Supermicro website product pages at
supermicro.com/products/nfo.
Installing 2.5" Drives to the Chassis Floor
1. Remove power as described in Section 3.1 and remove the chassis cover.
2. If necessary, remove the PCI expansion card from the chassis.
3. Remove the drive bays from the chassis.
4. Insert the solid-state drives into the drive bays and secure the drives with screws.
5. Secure each drive bay to the chassis floor using four screws.
6. Connect the drive cables to the motherboard and the power supply.
7. If necessary, reinstall the PCI expansion card.
8. Reinstall the chassis cover, reconnect the power cord, and power up the system.
Figure 3-4. Securing the Mounting Brackets to the Chassis Floor
Chapter 3: Maintenance and Component Installation
30
https://www.