Storage Drives; Installing The Storage Drive - Supermicro SuperServer SYS-E302-12D-4C User Manual

3.5 Storage Drives

Installing the Storage Drive

The CSE-E302iL can accommodate one fixed 2.5" storage drive of 7mm height, installed to
a mounting tray inside the chassis.
Installing the Hard Drive
The motherboard should be installed before installing the drive(s).
1. Make sure there is no power to the system as described in section 3.1 and remove the
chassis cover.
2. See section 3.2 for instructions on how to remove the top cover.
3. Remove the hard drive tray from the chassis.
4. On the mounting tray, open the latches on the side of the tray.
5. Slide one 2.5" 7mm drive into the top slot of the mounting tray. See Figure 3-5.
6. Close the latches on the side of the tray.
Chapter 3: Maintenance and Component Installation
Figure 3-4. Installing 7mm 2.5" Hard Drives
30