Control Panel - Supermicro SuperServer SYS-510D-4C-FN6P User Manual

Control Panel

Information LED
LAN2 LED
LAN1 LED
Feature Description
Information LED Alerts operator to several states, as noted in the table below.
LAN2 LED Indicates network activity on GLAN2 when flashing.
LAN1 LED Indicates network activity on GLAN1 when flashing.
HDD LED Indicates activity on the storage drives when flashing.
Steady on – Power on
Blinking at 4Hz – Checking BIOS/BMC integrity
Power LED Blinking at 4Hz and "i" LED is blue – BIOS firmware updating
Two blinks at 4Hz, one pause 2hz and "i" LED blue – BMC firmware updating
Blinking at 1Hz and "i" LED red – Fault detected
The reset button is used to reboot the system. Press the button with a slender
Reset Button
device such the tip of a pen.
The main power button is used to apply or remove power from the power supply to
the server. Turning off system power with this button removes the main power but
Power Button
maintains system power. To perform maintenance tasks, you must also unplug the
system before servicing.
Color, Status
Red, solid
Red, blinking at 1Hz
Red, blinking at 0.25Hz
Red, solid, with Power LED blinking
green
Blue and red, blinking at 10 Hz
Blue, solid
Blue, blinking at 1Hz
Blue, blinking at 2Hz
Blue, blinking at 4Hz
Blue, blinking at 10Hz with Power LED
blinking green
Figure 1-2. Control Panel
Control Panel Features
Information LED
Description
An overheat condition has occurred.
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power
supply.
Fault detected
Recovery mode
UID has been activated locally to locate the
server in a rack environment.
UID has been activated using the BMC to locate
the server in a rack environment.
BMC is resetting
BMC is setting factory defaults
BMC/BIOS firmware is updating
10
Chapter 1: Introduction
Power
Reset
Power LED
HDD